Battery Energy Storage System (BESS) - Training Guide
============================================================

MINIMUM RESOLUTION: 980 x 600 px
RECOMMENDED: 1920 x 1080 (16:9) or larger

SIMULATOR OVERVIEW
----------------------------------------
Battery energy storage system simulator covering Li-ion cell monitoring, BMS operation, charge/discharge cycles, and thermal management per IEC 62619 and UL 9540.

Standards: IEC 62619 · UL 9540 · NFPA 855

INTERFACE LAYOUT
----------------------------------------
- LEFT PANEL: System controls (Start/Stop/ESD/Reset, Mode toggle)
- CENTER: P&ID schematic with real-time process visualization
- RIGHT PANEL: System gauges, operational checklist, alarm list

OPERATING PROCEDURES
----------------------------------------
  Step 1: Pre-operation inspection complete
  Step 2: Verify HVAC cooling operational
  Step 3: Close DC contactors
  Step 4: Start PCS (power conversion system)
  Step 5: Set charge/discharge schedule
  Step 6: Monitor cell voltages and temperatures
  Step 7: Verify fire suppression system armed
  Step 8: Record round-trip efficiency

SCENARIOS
----------------------------------------

  Charge-Discharge Cycle:
  Complete full charge from grid, then discharge to peak-shave at rated power.

  Thermal Runaway Response:
  Detect thermal runaway precursors and execute emergency isolation and cooling.

  Energy Arbitrage:
  Buy low / sell high — schedule charge/discharge cycles for optimization.

ALARM RESPONSE
----------------------------------------
  THERMAL_RUNAWAY [ALARM]: Thermal runaway detected — evacuate
  CELL_OVERVOLT [ALARM]: Cell overvoltage >4.25V
  CELL_UNDERVOLT [WARNING]: Cell undervoltage <2.8V
  CELL_TEMP_HIGH [WARNING]: Cell temperature >45°C
  SOC_LOW [WARNING]: State of charge <10%

CONTROLS
--------
- START: Begin process operation
- STOP: Normal shutdown
- EMERGENCY STOP: Immediate shutdown of all systems
- RESET: Clear ESD condition and reset to standby
- TOGGLE MODE: Switch between Manual and Auto control
- Fullscreen: Click the fullscreen button in header
- EXIT: Return to BlueSim portal
- HELP: Opens this training guide