Grid Synchronization - Training Guide
============================================================

MINIMUM RESOLUTION: 980 x 600 px
RECOMMENDED: 1920 x 1080 (16:9) or larger

SIMULATOR OVERVIEW
----------------------------------------
Grid synchronization simulator covering synchroscope operation, voltage matching, frequency matching, and phase-angle alignment per IEEE 1547 and IEC 60034.

Standards: IEEE 1547 · IEC 60034 · ANSI C84.1

INTERFACE LAYOUT
----------------------------------------
- LEFT PANEL: System controls (Start/Stop/ESD/Reset, Mode toggle)
- CENTER: P&ID schematic with real-time process visualization
- RIGHT PANEL: System gauges, operational checklist, alarm list

OPERATING PROCEDURES
----------------------------------------
  Step 1: Start prime mover
  Step 2: Bring generator to rated speed
  Step 3: Adjust excitation — match bus voltage
  Step 4: Fine-tune governor — match bus frequency
  Step 5: Monitor synchroscope rotation
  Step 6: Close breaker at 12 o'clock position
  Step 7: Verify forward power flow
  Step 8: Increase load gradually

SCENARIOS
----------------------------------------

  Manual Synchronization:
  Match voltage, frequency, and phase angle manually using synchroscope.

  Auto-Sync Check:
  Verify automatic synchronizer performance and relay settings.

  Black Start Procedure:
  Restore power from dead bus using diesel generator, then sync additional units.

ALARM RESPONSE
----------------------------------------
  SYNC_FAIL [ALARM]: Synchronization out of limits — breaker blocked
  REVERSE_POWER [ALARM]: Reverse power detected
  OVER_FREQ [WARNING]: Generator frequency >51 Hz
  UNDER_VOLT [WARNING]: Generator voltage <95%
  PHASE_SLIP [ALARM]: Phase angle slip >10°/s

CONTROLS
--------
- START: Begin process operation
- STOP: Normal shutdown
- EMERGENCY STOP: Immediate shutdown of all systems
- RESET: Clear ESD condition and reset to standby
- TOGGLE MODE: Switch between Manual and Auto control
- Fullscreen: Click the fullscreen button in header
- EXIT: Return to BlueSim portal
- HELP: Opens this training guide