Flammable Atmosphere / LEL Monitoring - Training Guide ============================================================ MINIMUM RESOLUTION: 980 x 600 px RECOMMENDED: 1920 x 1080 (16:9) or larger SIMULATOR OVERVIEW ---------------------------------------- Flammable atmosphere and LEL monitoring simulator covering catalytic/IR detector operation, alarm response, and confined space entry per IEC 60079 and NFPA 497. Standards: IEC 60079 · NFPA 497/499 · OSHA 1910.146 INTERFACE LAYOUT ---------------------------------------- - LEFT PANEL: System controls (Start/Stop/ESD/Reset, Mode toggle) - CENTER: P&ID schematic with real-time process visualization - RIGHT PANEL: System gauges, operational checklist, alarm list OPERATING PROCEDURES ---------------------------------------- Step 1: Zero calibrate detector Step 2: Span calibrate with test gas Step 3: Verify detector responds within 30s Step 4: Take initial atmospheric reading Step 5: Record LEL O2 H2S CO levels Step 6: Continuous monitoring active Step 7: Verify ventilation adequate Step 8: Issue work permit SCENARIOS ---------------------------------------- Routine LEL Monitoring: Perform routine atmospheric monitoring — verify zero and span calibration. Confined Space Entry: Establish continuous LEL monitoring for confined space entry. Gas Leak Response: Detect rising LEL levels, trace leak source, execute emergency ventilation. ALARM RESPONSE ---------------------------------------- LEL_HIGH [ALARM]: LEL exceeds 25% — evacuate area LEL_WARN [WARNING]: LEL exceeds 10% — investigate O2_LOW [ALARM]: Oxygen <19.5% — do not enter O2_HIGH [WARNING]: Oxygen >23.5% — enrichment hazard SENSOR_FAULT [ALARM]: Detector sensor fault CONTROLS -------- - START: Begin process operation - STOP: Normal shutdown - EMERGENCY STOP: Immediate shutdown of all systems - RESET: Clear ESD condition and reset to standby - TOGGLE MODE: Switch between Manual and Auto control - Fullscreen: Click the fullscreen button in header - EXIT: Return to BlueSim portal - HELP: Opens this training guide